CHAPTER 2
Services Processing Cards
IN THIS CHAPTER
Services Processing Cards Specifications | 9
Services Processing Cards Specifications
IN THIS SECTION
Services Processing Card SRX5K-SPC-2-10-40 Specifications | 9
Services Processing Card SRX5K-SPC-4-15-320 Specifications | 13
Services Processing Card SRX5K-SPC3 Specifications | 18
Services Processing Card SRX5K-SPC-2-10-40 Specifications
The SRX5K-SPC-2-10-40 Services Processing Card (SPC) contains two Services Processing Units (SPUs),
which provide the processing power to run integrated services such as firewall, IPsec, and IDP (see
Figure 2 on page
10). All traffic traversing the services gateway is passed to an SPU to have services
processing applied to it. Traffic is intelligently distributed by I/O cards (IOCs) to SPUs for services processing.
The services gateway must have at least one SPC installed. You can install additional SPCs to increase
services processing capacity.
You can install SPCs in any of the slots that are not reserved for Switch Control Boards (SCBs). If a slot is
not occupied by a card, you must install a blank panel to shield the empty slot and to allow cooling air to
circulate properly through the device.
Figure 2 on page 10
shows a typical SPC supported on the services gateway.
9