Services Processing Card Srx5K-Spc-2-10-40 Specifications - Juniper SRX5600 Hardware Manual

99
Figure 42: Typical SPC
For detailed information about SPCs supported by the services gateway, see the SRX5400, SRX5600, and
SRX5800 Services Gateway Card Reference at www.juniper.net/documentation/.

Services Processing Card SRX5K-SPC-2-10-40 Specifications

The SRX5K-SPC-2-10-40 Services Processing Card (SPC) contains two Services Processing Units (SPUs),
which provide the processing power to run integrated services such as firewall, IPsec, and IDP (see
Figure 43 on page 100). All traffic traversing the services gateway is passed to an SPU to have services
processing applied to it. Traffic is intelligently distributed by I/O cards (IOCs) to SPUs for services processing.
The services gateway must have at least one SPC installed. You can install additional SPCs to increase
services processing capacity.
You can install SPCs in any of the slots that are not reserved for Switch Control Boards (SCBs). If a slot is
not occupied by a card, you must install a blank panel to shield the empty slot and to allow cooling air to
circulate properly through the device.
Figure 43 on page 100 shows a typical SPC supported on the services gateway.