Revision - Cisco Catalyst 4500 Series Command Reference Manual

revision

revision
To set the MST configuration revision number, use the revision command. To return to the default settings,
use the no form of this command.
Syntax Description
version
Defaults Revision version is set to 0.
Command Modes
MST configuration mode
Command History Release
12.1(12c)EW
Usage Guidelines If two Catalyst 4500 series switches have the same configuration but have different configuration
revision numbers, they are considered to be part of two different regions.
Caution Be careful when using the revision command to set the MST configuration revision number because a
mistake can put the switch in a different region.
Examples
This example shows how to set the configuration revision number:
Switch(config-mst)# revision 5
Switch(config-mst)#
Related Commands Command
instance
name
show spanning-tree mst
spanning-tree mst configuration
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
2-578
revision version
no revision
Configuration revision number; valid values are from 0 to 65535.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Description
Maps a VLAN or a set of VLANs to an MST instance.
Sets the MST region name.
Displays MST protocol information.
Enters the MST configuration submode.
OL-25342 -01