Show Running-Config - Cisco Catalyst 4500 Series Command Reference Manual

show running-config

show running-config
To display the module status and configuration, use the show running-config command.
Syntax Description
module slot
Defaults This command has no default settings.
Command Modes Privileged EXEC mode
Command History Release
12.1(8a)EW
Usage Guidelines In some cases, you might see a difference in the duplex mode displayed when you enter the
interfaces
mode displayed in the
The
running-config
The
but no configuration for the speed. When no speed is displayed in the output, it indicates that the
interface speed is configured to be auto and that the duplex mode shown becomes the operational setting
once the speed is configured to something other than auto. With this configuration, it is possible that the
operating duplex mode for that interface does not match the duplex mode shown with the
running-config
Examples
This example shows how to display the module and status configuration for all modules:
Switch# show running-config
03:23:36:%SYS-5-CONFIG_I:Configured from console by consolesh runn
Building configuration...
Current configuration:3268 bytes
!
version 12.1
no service pad
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname Switch
!
!
power supplies required 1
ip subnet-zero
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
2-876
show running-config [module slot]
(Optional) Specifies the module slot number; valid values are from 1 to 6.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
command and the show running-config
show interfaces
show interfaces command shows the operating mode for an interface, while the
command shows the configured mode for an interface.
show running-config command output for an interface may display a duplex mode configuration
command.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
command. If you do see a difference, the duplex
command is the actual duplex mode that the interface is running.
show
show
show
OL-25342 -01