Show Auto Qos - Cisco Catalyst 4500 Series Command Reference Manual

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches

show auto qos

To display the automatic quality of service (auto-QoS) configuration that is applied, use the show auto
qos user EXEC command.
Syntax Description
interface interface-id
begin
exclude
include
expression
Command Modes
Privileged EXEC mode
Command History Release
12.1(19)EW
Usage Guidelines The show auto qos interface interface-id command displays the auto-QoS configuration; it does not
display any user changes to the configuration that might be in effect.
To display information about the QoS configuration that might be affected by auto-QoS on a
non-Supervisor Engine 6-E, use one of these commands:
•
•
•
•
Expressions are case sensitive. For example, if you enter exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples This example shows output from the show auto qos command when auto-QoS is enabled:
Switch# show auto qos
GigabitEthernet1/2
auto qos voip cisco-phone
Switch#
Related Commands Command
auto qos voip
OL-25342 -01
show auto qos [interface [interface-id]] [{begin | exclude | include} expression]
(Optional) Displays auto-QoS information for the specified interface or
for all interfaces. Valid interfaces include physical ports.
(Optional) Begins with the line that matches the expression.
(Optional) Excludes lines that match the expression.
(Optional) Includes lines that match the specified expression.
(Optional) Expression in the output to use as a reference point.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
show qos
show qos map
show qos interface interface-id
show running-config
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
Description
Automatically configures quality of service (auto-QoS) for Voice
over IP (VoIP) within a QoS domain.
show auto qos
2-619