Show Policy-Map Interface - Cisco Catalyst 4500 Series Command Reference Manual

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches

show policy-map interface

To display the statistics and configurations of the input and output policies that are attached to an
interface, use the show policy-map interface command.
Syntax Description fastethernet interface-number
gigabitethernet interface-number
port-channel number
vlan vlan_id
input
output
Defaults
This command has no default settings.
Command Modes
Privileged EXEC mode
Command History Release
12.1(8a)EW
12.1(12c)EW
12.2(25)SG
Examples
This example shows how to display the statistics and configurations of all input and output policies
attached to an interface:
Switch# show policy-map interface
FastEthernet6/1
service-policy input:ipp5-policy
OL-25342 -01
show policy-map interface [{fastethernet interface-number} | {gigabitethernet
interface-number} | {port-channel number} | {vlan vlan_id}] [input | output]
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Added support for extended VLAN addresses.
Displays results for full flow policing.
class-map:ipp5 (match-all)
0 packets
match:ip precedence 5
set:
ip precedence 6
class-map:class-default (match-any)
0 packets
match:any
0 packets
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
(Optional) Specifies the Fast Ethernet 802.3 interface.
(Optional) Specifies the Gigabit Ethernet 802.3z interface.
(Optional) Specifies the port channel.
(Optional) Specifies the VLAN ID; valid values are from 1
to 4094.
(Optional) Specifies input policies only.
(Optional) Specifies output policies only.
show policy-map interface
2-839