Cisco Catalyst 4500 Series Command Reference Manual page 722

show etherchannel
Port
Fa5/4
Age of the port in the current state: 02h:40m:35s
Port: Fa5/5
------------
Port state
Channel group = 1
Port-channel
Port indx
Flags:
Timers: H - Hello timer is running.
<...output truncated...>
Switch#
This example shows how to display the protocol enabled:
Switch# show etherchannel protocol
Group: 12
----------
Protocol:
Group: 24
----------
Protocol:
Switch#
Related Commands Command
channel-group
interface port-channel
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
2-664
Flags State Timers
d U1/S1
= EC-Enbld Down Not-in-Bndl Usr-Config
Mode = Desirable
= null GC
= 0 Load = 0x00
S - Device is sending Slow hello.
A - Device is in Auto mode.
S - Switching timer is running.
Channel-group listing:
-----------------------
PAgP
- (Mode ON)
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Interval Count Priority
1s 0 128
Gcchange = 0
= 0x00000000 Psudo-agport = Po1
C - Device is in Consistent state.
P - Device learns on physical port.
Q - Quit timer is running.
I - Interface timer is running.
Description
Assigns and configures an EtherChannel interface to an
EtherChannel group.
Accesses or creates a port-channel interface.
Method Ifindex
Any 0
OL-25342 -01