Monitor Capture {Access-List | Class-Map - Cisco Catalyst 4500 Series Command Reference Manual

monitor capture {access-list | class-map}

monitor capture {access-list | class-map}
To specify an access list or class map as the core filter, use the monitor capture {access-list |
class-map} command. To remove the filter, use the no form of this command.
Syntax Description
name
access-list name
class-map name
Defaults
None
Command Modes
Privileged EXEC mode
Command History Release
IOS XE 3.3.0SG/
15.1(1)SG
Usage Guidelines
The access list or class map is defined with configuration commands. The access list or class map should
be defined prior to entering the monitor capture command. We can specify the core filter as a class map,
access lis, t or an explicit in-line filter. If the filter has already been specified when you enter the monitor
capture command, it replaces the older one.
Examples The following example shows how to define a core system filter using an existing ACL or class-map:
Switch# monitor capture mycap filter access-list myacl
Switch# monitor capture mycap filter class-map mycm
Switch# no monitor capture mycap filter class-map mycm
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
2-444
monitor capture name {access-list name | class-map name}
no monitor capture name {access-list name | class-map name}
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Specifies a capture point.
Specifies access list name
Specifies class map name
OL-25342 -01