Nmsp - Cisco Catalyst 4500 Series Command Reference Manual

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches

nmsp

To configure Network Mobility Services Protocol (NMSP) on the switch, use the nmsp command. This
command is available only when your switch is running the cryptographic (encrypted) software image.
Use the no form of this command to return to the default setting.
Syntax Description
enable
notification interval
attachment
location
interval-seconds
Defaults
NMSP is disabled, NMSP notification interval attachment and NMSP notification interval location
defaults are 30 seconds.
Command Modes
Global configuration mode
Command History Release
12.2(52)SG
Usage Guidelines
Use the nmsp global configuration command to enable the switch to send encrypted NMSP location and
attachment notifications to a Cisco Mobility Services Engine (MSE).
Examples
This example shows how to enable NMSP on a switch and set the location notification time to 10
seconds:
Switch(config)# nmsp enable
Switch(config)# nmsp notification interval location 10
Switch(config)#
Related Commands Command
clear nmsp statistics
nmsp attachment suppress
show nmsp
OL-25342 -01
nmsp {enable | {notification interval {attachment | location} interval-seconds}}
no nmsp {enable | {notification interval {attachment | location} interval-seconds}}
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
Enables the NMSP features on the switch.
Specifies the NMSP notification interval.
Specifies the attachment notification interval.
Specifies the location notification interval.
Duration in seconds before a switch sends the location or attachment
updates to the MSE. The range is 1 to 30; the default is 30.
Description
Clears the NMSP statistic counters.
Suppress reporting attachment information from a specified
interface.
Displays the NMSP information.
nmsp
2-471