Show Qos Interface - Cisco Catalyst 4500 Series Command Reference Manual

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches

show qos interface

To display queueing information, use the show qos interface command.
Syntax Description
fastethernet interface-number
gigabitethernet interface-number
vlan vlan_id
port-channel number
Defaults This command has no default settings.
Command Modes Privileged EXEC mode
Command History Release
12.1(8a)EW
12.1(13)EW
12.1(19)EW
Usage Guidelines
This command is not supported on the Supervisor Engine 6-E and Catalyst 4900M chassis.
Examples
This example shows how to display queueing information:
Switch# show qos interface fastethernet 6/1
Switch#
OL-25342 -01
show qos interface {fastethernet interface-number | gigabitethernet interface-number} |
[vlan vlan_id | port-channel number]
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Added support for extended VLAN addresses.
Display changed to include the Port Trust Device.
QoS is enabled globally
Port QoS is enabled
Administrative Port Trust State: 'dscp'
Operational Port Trust State: 'untrusted'
Port Trust Device:'cisco-phone'
Default DSCP:0 Default CoS:0
Tx-Queue Bandwidth
(bps)
1 31250000
2 31250000
3 31250000
4 31250000
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
Specifies the Fast Ethernet 802.3 interface.
Specifies the Gigabit Ethernet 802.3z interface.
(Optional) Specifies the VLAN ID; valid values are from 1 to
4094.
(Optional) Specifies the port channel; valid ranges are from
1 to 64.
ShapeRate Priority
(bps)
disabled N/A
disabled N/A
disabled normal
disabled N/A
QueueSize
(packets)
240
240
240
240
show qos interface
2-865