Cisco Catalyst 4500 Series Command Reference Manual page 554

police rate
Command Modes Policy-map configuration mode
Command History Release
12.2(40)SG
Usage Guidelines
Use the police rate command to limit traffic on the basis of pps, bps, or a percentage of interface
bandwidth.
If the police rate command is issued, but the a rate is not specified, traffic that is destined will be policed
on the basis of bps.
Examples
This example shows how to configure policing on a class to limit traffic to an average rate of 1,500,000
bps:
Switch(config)# class-map c1
Switch(config-cmap)# match access-group 140
Switch(config-cmap)# exit
Switch(config)# policy-map p1
Switch(config-pmap)# class c1
Switch(config-pmap-c)# police rate 1500000
Switch(config-pmap-c)# exit
Related Commands Command
policy-map
show policy-map
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
2-496
Chapter 2
Modification
This command was introduced on the Catalyst 4500 series switch using a Supervisor
Engine 6-E.
Description
Creates or modifies a policy map that can be attached to multiple
ports to specify a service policy and to enter policy-map
configuration mode.
Displays information about the policy map.
Cisco IOS Commands for the Catalyst 4500 Series Switches
burst 500000
OL-25342 -01