Port-Channel Load-Balance - Cisco Catalyst 4500 Series Command Reference Manual

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches

port-channel load-balance

To set the load-distribution method among the ports in the bundle, use the port-channel load-balance
command. To reset the load distribution to the default, use the no form of this command.
Syntax Description
method
Defaults
Load distribution on the source XOR destination IP address is enabled.
Command Modes Global configuration mode
Command History Release
12.1(8a)EW
Usage Guidelines The following values are valid for the load-distribution method:
•
•
•
•
•
•
•
•
•
Examples
This example shows how to set the load-distribution method to the destination IP address:
Switch(config)# port-channel load-balance dst-ip
Switch(config)#
This example shows how to set the load-distribution method to the source XOR destination IP address:
Switch(config)# port-channel load-balance src-dst-port
Switch(config)#
OL-25342 -01
port-channel load-balance method
no port-channel load-balance
Specifies the load distribution method. See the "Usage Guidelines" section for more
information.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
dst-ip—Load distribution on the destination IP address
dst-mac—Load distribution on the destination MAC address
dst-port—Load distribution on the destination TCP/UDP port
src-dst-ip—Load distribution on the source XOR destination IP address
src-dst-mac—Load distribution on the source XOR destination MAC address
src-dst-port—Load distribution on the source XOR destination TCP/UDP port
src-ip—Load distribution on the source IP address
src-mac—Load distribution on the source MAC address
src-port—Load distribution on the source port
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
port-channel load-balance
2-503