Cisco Catalyst 4500 Series Command Reference Manual page 655

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
This example shows how the DSCP value is set according to the CoS value defined in the table map
called table-map1.
Switch# configure terminal
Switch(config)# policy-map policy1
Switch(config-pmap)# class class-default
Switch(config-pmap-c)# set dscp cos table table-map1
Switch(config-pmap-c)# end
Switch#
Related Commands Command
match (class-map
configuration)
policy-map
service-policy (policy-map
class)
set cos
set precedence
show policy-map
show policy-map interface
table-map (value mapping)
(refer to Cisco IOS
documentation)
OL-25342 -01
Description
Defines the match criteria for a class map.
Creates or modifies a policy map that can be attached to multiple
ports to specify a service policy and to enter policy-map
configuration mode.
Creates a service policy that is a quality of service (QoS) policy
within a policy map.
Sets IP traffic by setting a class of service (CoS).
Sets the precedence value in the packet header.
Displays information about the policy map.
Displays the statistics and configurations of the input and output
policies that are attached to an interface.
Modifies metric and tag values when the IP routing table is
updated with BGP learned routes.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
set dscp
2-597