Cisco Catalyst 4500 Series Command Reference Manual page 963

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
This example shows how to display the VLAN parameters for VLAN 3 only:
Switch# show vlan id 3
VLAN Name
---- -------------------------------- --------- -------------------------------
3
VLAN Type
---- ----- ---------- ----- ------ ------ -------- ---- -------- ------ ------
3
Switch#
Table 2-34
Table 2-34
Field
VLAN
Name
Status
Ports
Type
SAID
MTU
Parent
RingNo
BrdgNo
Stp
The following example shows how to verify that the primary VLAN and secondary VLANs are correctly
associated with each other and the same association also exists on the PVLAN port:
Switch# show vlan private-vlan
Primary Secondary Type
-------
------------------------------------------
10
The following example shows how to remove the VLAN association:
Switch(config)# vlan 10
Switch(config-vlan)# private-vlan association remove 100
Switch(config-vlan)# end
Switch# show vlan private
Primary Secondary Type
------- --------- ----------------- ------------------------------------------
10
OL-25342 -01
VLAN0003
SAID MTU
enet 100003 1500
describes the fields in the show vlan command output.
show vlan Command Output Fields
Description
VLAN number.
Name, if configured, of the VLAN.
Status of the VLAN (active or suspend).
Ports that belong to the VLAN.
Media type of the VLAN.
Security Association Identifier value for the VLAN.
Maximum transmission unit size for the VLAN.
Parent VLAN, if one exists.
Ring number for the VLAN, if applicable.
Bridge number for the VLAN, if applicable.
Spanning Tree Protocol type used on the VLAN.
---------
100 community
primary
100 community
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
Status Ports
active Fa5/9
Parent RingNo BridgeNo Stp
- - -
Ports
-----------------
Fa3/1, Fa3/2
Ports
BrdgMode Trans1 Trans2
- - 303 0
show vlan
2-905