Cisco Catalyst 4500 Series Command Reference Manual page 202

debug condition standby
This example shows the display if you try to turn off the last standby debug condition:
Switch# no debug condition standby vlan 1 0
This condition is the last standby condition set.
Removing all conditions may cause a flood of debugging
messages to result, unless specific debugging flags
are first removed.
Proceed with removal? [yes/no]: n
% Operation aborted
Switch#
Related Commands Command
undebug condition standby
(same as no debug condition
standby)
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
2-144
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Description
Disables debugging output.
OL-25342 -01