Dot1X Timeout - Cisco Catalyst 4500 Series Command Reference Manual

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches

dot1x timeout

To set the reauthentication timer, use the dot1x timeout command. To return to the default setting, use
the no form of this command.
Syntax Description
reauth-period seconds
reauth-period server
quiet-period seconds
tx-period seconds
supp-timeout seconds
server-timeout seconds
Defaults
The default settings are as follows:
•
•
•
•
•
Command Modes
Interface configuration mode
Command History Release
12.1(12)EW
12.2(25)EWA
OL-25342 -01
dot1x timeout {reauth-period {seconds | server} | quiet-period seconds | tx-period seconds |
supp-timeout seconds | server-timeout seconds}
no dot1x timeout {reauth-period | quiet-period | tx-period | supp-timeout | server-timeout}
Number of seconds between reauthentication attempts; valid values are
from 1 to 65535. See the "Usage Guidelines" section for more
information.
Number of seconds between reauthentication attempts; valid values are
from 1 to 65535 as derived from the Session-Timeout RADIUS attribute.
See the "Usage Guidelines" section for more information.
Number of seconds that the switch remains in the quiet state following
a failed authentication exchange with the client; valid values are from 0
to 65535 seconds.
Number of seconds that the switch waits for a response to an
EAP-request/identity frame from the client before retransmitting the
request; valid values are from 1 to 65535 seconds.
Number of seconds that the switch waits for the retransmission of
EAP-Request packets; valid values are from 30 to 65535 seconds.
Number of seconds that the switch waits for the retransmission of
packets by the back-end authenticator to the authentication server; valid
values are from 30 to 65535 seconds.
Reauthentication period is 3600 seconds.
Quiet period is 60 seconds.
Transmission period is 30 seconds.
Supplicant timeout is 30 seconds.
Server timeout is 30 seconds.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Support for selecting the reauthentication timer from the "server" was added.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
dot1x timeout
2-219