Cisco Catalyst 4500 Series Command Reference Manual page 50

How to Find Command Options
Table 1-2 How to Find Command Options (continued)
Command
Switch(config-if)# channel-group ?
<1-256> Channel group number
Switch(config-if)#channel-group
Switch(config-if)# channel-group 1 ?
mode Etherchannel Mode of the interface
Switch(config-if)#
Switch(config-if)# channel-group 1 mode ?
auto Enable PAgP only if a PAgP device is detected
desirable Enable PAgP unconditionally
on Enable Etherchannel only
Switch(config-if)#
Switch(config-if)# channel-group 1 mode auto ?
<cr>
Switch(config-if)#
Switch(config-if)# channel-group 1 mode auto
Switch(config-if)#
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
1-4
Chapter 1 Command-Line Interface
Purpose
After you enter the group keyword,
enter a ? to display what you must
enter next on the command line. In
this example, you must enter a channel
group number from 1 to 256.
Because a is not displayed, it
<cr>
indicates that you must enter more
information to complete the
command.
After you enter the channel group
number, enter a ? to display what you
must enter next on the command line.
In this example, you must enter the
mode keyword.
Because a is not displayed, it
<cr>
indicates that you must enter more
information to complete the
command.
After you enter the mode keyword,
enter a ? to display what you must
enter next on the command line. In
this example, you must enter the auto,
desirable, or on keyword.
Because a is not displayed, it
<cr>
indicates that you must enter more
information to complete the
command.
In this example, the auto keyword is
entered. After you enter the auto
keyword, enter a ? to display what you
must enter next on the command line.
Because a is displayed, it
<cr>
indicates that you can press Return to
complete the command. If additional
keywords are listed, you can enter
more keywords or press Return to
complete the command.
In this example, press Return to
complete the command.
OL-25342 -01