Show Policy-Map Control-Plane - Cisco Catalyst 4500 Series Command Reference Manual

show policy-map control-plane

show policy-map control-plane
To display the configuration either of a class or of all classes for the policy map of a control plane, use
the show policy-map control-plane command.
Syntax Description
input
class class-name
Defaults This command has no default settings.
Command Modes Privileged EXEC mode
Command History Release
12.2(31)SG
Usage Guidelines This command is not supported on the Supervisor Engine 6-E and Catalyst 4900M chassis.
The show policy-map control-plane command displays information for aggregate control-plane
services that control the number or rate of packets that are going to the process level.
Examples This example shows that the policy map TEST is associated with the control plane. This policy map
polices traffic that matches the class-map TEST, while allowing all other traffic (that matches the
class-map class-default) to go through as is.
Switch# show policy-map control-plane
Control Plane
Service-policy input: system-cpp-policy
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
2-836
show policy-map control-plane [input [class class-name] | [class class-name]]
(Optional) Displays statistics for the attached input policy.
(Optional) Displays the name of the class.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Class-map: system-cpp-eapol (match-all)
0 packets
Match: access-group name system-cpp-eapol
Class-map: system-cpp-bpdu-range (match-all)
0 packets
Match: access-group name system-cpp-bpdu-range
Class-map: system-cpp-cdp (match-all)
28 packets
Match: access-group name system-cpp-cdp
police: Per-interface
Conform: 530 bytes Exceed: 0 bytes
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Table 2-32 describes the fields shown in the display.
OL-25342 -01