Chapter 2
Cisco IOS Commands for the Catalyst 4500 Series Switches
Table 2-7
Active Supervisor Uplink
Ports
A1
SFP+ —
SFP
SFP
Choose 1-Gigabit operation through the command line interface.
SFP
Examples
This example shows how to select the Gigabit Ethernet uplinks:
Switch(config)# hw-module uplink select gigabitethernet
A reload of the active supervisor is required to apply the new configuration.
Switch(config)# exit
Switch#
Note
The Gigabit Ethernet uplinks will be active after the next reload.
This example shows how to select the Gigabit Ethernet uplinks in a redundant system in SSO mode:
Switch(config)# hw-module uplink select gigabitethernet
A 'redundancy reload shelf' or power-cycle of chassis is required to apply the new
configuration
Switch(config)# exit
Switch#
The Gigabit Ethernet uplinks will be active after the next reload of the chassis/shelf. Use the
Note
redundancy reload shelf command to reload the chassis/shelf.
This example shows how to select the Gigabit Ethernet uplinks in a redundant system in RPR mode:
Switch(config)# hw-module uplink select gigabitethernet
A reload of the active supervisor is required to apply the new configuration.
Switch(config)# exit
Switch#
The Gigabit Ethernet uplinks will be active on a switchover or reload of the active supervisor engine.
Note
This example shows how to select all the uplinks in a redundant system in SSO mode:
Switch(config)# hw-module uplink select all
Warning: This configuration mode may disable slot10.
A 'redundancy reload shelf' or power-cycle of chassis is required to apply the new
configuration.
Switch(config)# exit
Switch#
Note
If you select the all keyword, only the Drome board will be supported in the tenth slot of the supervisor
engine.
OL-25342 -01
Uplink Options for Redundant Supervisor Mode
Standby Supervisor Uplink
Ports
A2
A3
A4
B1
—
—
SFP
—
—
—
SFP+ —
—
—
—
SFP
SFP
—
—
SFP
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
Speeds Achievable with this
B2
B3
B4
Combination of Pluggables
—
—
—
11 Gbps
—
—
11 Gbps
—
—
—
2 Gbps
SFP
—
—
4 Gbps
hw-module uplink select
2-265