Redundancy Config-Sync Mismatched-Commands - Cisco Catalyst 4500 Series Command Reference Manual

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches

redundancy config-sync mismatched-commands

To move the active supervisor engine into the Mismatched Command List (MCL) and resets the standby
supervisor engine, use the redundancy config-sync mismatched-commands command.
If your active and standby supervisors engines are running different versions of Cisco IOS, some of their
CLIs will not be compatible. If such commands are already present in the running configuration of the
active supervisor engine and the syntax-check for the command fails at the standby supervisor engine
while it is booting, you must move the active supervisor engine into the Mismatched Command List
(MCL).
Syntax Description
ignore
validate
Defaults This command has no default settings.
Command Modes
Privileged EXEC mode
Command History Release
12.2(31)SGA
12.2(44)SG
Usage Guidelines
The following is a log entry example for mismatched commands:
00:06:31: Config Sync: Bulk-sync failure due to Servicing Incompatibility. Please check
full list of mismatched commands via:
show redundancy config-sync failures mcl
00:06:31: Config Sync: Starting lines from MCL file:
interface GigabitEthernet7/7
! <submode> "interface"
- ip address 11.0.0.1 255.0.0.0
! </submode> "interface"
To display all mismatched commands, use the show redundancy config-sync failures mcl command.
To clean the MCL, remove all mismatched commands from the active supervisor engine's running
configuration, revalidate the MCL with a modified running configuration using the redundancy
config-sync validate mismatched-commands command, then reload the standby supervisor engine.
You could also ignore the MCL by entering the redundancy config-sync ignore
mismatched-commands command and reloading the standby supervisor engine; the system changes to
SSO mode.
OL-25342 -01
redundancy config-sync {ignore | validate} mismatched-commands
Ignore the mismatched command list.
Revalidate the mismatched command list with the modified
running-configuration.
Modification
This command was introduced on the Catalyst 4500 series switch.
Updated command name from issu config-sync to redundancy config-sync.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
redundancy config-sync mismatched-commands
2-555