Chapter 2
Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
logging event power-inline-status
Use the logging event power-inline-status interface configuration command to enable the logging of
Power over Ethernet (PoE) events. Use the no form of this command to disable the logging of PoE status
events; however, the no form of this command does not disable PoE error events.
Syntax Description
power-inline-status
Defaults
Logging of PoE events is enabled.
Command Modes
Interface configuration
Command History
Release
12.2(53)SE2
Usage Guidelines
The power-inline-status keyword is available only on PoE interfaces.
Examples
This example shows how to enable logging of PoE events on a port:
Switch(config-if)# interface gigabitethernet1/0/1
Switch(config-if)# logging event power-inline-status
Switch(config-if)#
Related Commands
Command
power inline
show controllers
power inline
OL-21522-02
logging event power-inline-status
no logging event power-inline-status
Enable the logging of PoE messages.
Modification
This command was introduced.
Description
Configures the power management mode for the specified PoE port or for all
PoE ports.
Displays the values in the registers of the specified PoE controller.
Catalyst 3750-X and 3560-X Switch Command Reference
logging event power-inline-status
2-331