Dot1X Auth-Fail Vlan - Cisco Catalyst 4500 Series Command Reference Manual

dot1x auth-fail vlan

dot1x auth-fail vlan
To enable the auth-fail VLAN on a port, use the dot1x auth-fail vlan command. To return to the default
setting, use the no form of this command.
Syntax Description
vlan-id
Defaults This command has no default settings.
Command Modes
Interface configuration mode
Command History Release
12.2(25)SG
Examples This example shows how to configure the auth-fail VLAN on Fast Ethernet interface 4/3:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# interface fastethernet4/3
Switch(config-if)# dot1x auth-fail vlan 40
Switch(config-if)# end
Switch#
Related Commands Command
dot1x max-reauth-req
show dot1x
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
2-198
dot1x auth-fail vlan vlan-id
no dot1x auth-fail vlan vlan-id
Specifies a VLAN in the range of 1 to 4094.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Description
Sets the maximum number of times that the switch will
retransmit an EAP-Request/Identity frame to the client
before restarting the authentication process.
Displays dot1x information.
OL-25342 -01