Cisco Catalyst 4500 Series Command Reference Manual page 517

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
learning
remote vlan vlan_id
source
Port-channel interface-number
cpu
queue queue_id
acl
input
error
log/copy
punt
rx
output
l2-forward
bridge-cpu
ip-option
ipv6-scope-check-fail
l2-src-index-check-fail
mcast-rpf-fail
non-arpa
router-cpu
ttl-expired
adj-same-if
bridged
1
2
3
4
ucast-rpf-fail
all
OL-25342 -01
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
(Optional) Enables host learning on ingress-enabled destination
ports.
Specifies an RSPAN source or destination session on a switch.
Specifies a SPAN source.
Specifies a port-channel interface; valid values are from 1 to 64.
Causes traffic received or sent from the CPU to be copied to the
destination of the session.
(Optional) Specifies that only traffic received on the specific
CPU subqueue should be copied to the destination of the
session. Valid values are from 1 to 64, or by the following
names: all, control-packet, esmp, mtu-exceeded,
unknown-port-vlan-mapping, unknown-sa, acl input, acl input
copy, acl input error, acl input forward, acl input punt, acl
output, acl output copy, acl output error, acl output forward, acl
output punt, l2-forward, adj-same-if, bridge-cpu, ip-option,
ipv6-scope-check-fail, l2-src-index-check-fail, mcast-rpf-fail,
non-arpa, router-cpu, ttl-expired, ucast-rpf-fail, l3-forward,
forward, glean, receive.
(Optional) Specifies input and output ACLs; valid values are
from 14 to 20.
Specifies input ACLs; valid values are from 14 to 16.
Specifies the ACL software errors.
Specifies packets for ACL logging.
Specifies packets punted due to overflows.
Specifies monitoring received traffic only.
Specifies output ACLs; valid values are from 17 to 20.
(Optional) Layer 2 or Layer 3 exception packets.
Specifies packets bridged to CPU.
Specifies packets with an IP option.
Specifies IPv6 packets with scope-check failures.
Specifies IP packets with mismatched SRC MAC and SRC IP
addresses.
Specifies IPv4/IPv6 multicast RPF failures.
Specifies packets with non-ARPA encapsulation.
Specifies software routed packets.
Specifies IPv4 routed pacekts exceed TTL.
Specifies packets routed to the incoming interface.
Specifies Layer 2 bridged packets.
Specifies packets with the highest priority.
Specifies packets with the a high priority.
Specifies packets with the a medium priority.
Specifies packets with the a low priority.
Specifies IPv4/IPv6 Unicast RPF failures.
(Optional) all queues.
monitor session
2-459