Macro Auto Processing - Cisco Catalyst 4500 Series Command Reference Manual

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches

macro auto processing

Only use this command when Auto SmartPorts (ASP) is enabled globally; when ASP is disabled
Note
globally, interface-level control has no effect.
Use the macro auto processing interface configuration command to enable ASP macros on a specific
interface. Use the no form of this command to disable ASP on a specific interface before ASP is enabled
globally.
Syntax Description
fallback cdp
fallback lldp
Defaults Fallback mechanism is CDP.
Command Modes Interface level configuration
Command History Release
12.2(54)SG
Usage Guidelines The no macro auto processing command should be configured on all interfaces where ASP is not
desirable (such as Layer 3 and EtherChannel interfaces) before ASP is enabled globally.
At the interface level, the default fallback mechanism is CDP. To change the mechanism to LLDP, enter
the no macro auto processing fallback cdp command, followed by the macro auto processing
fallback lldp command.
This example shows how to enable the feature on an interface:
Examples
Switch(config)# interface Gi3/1
Switch(config-if)# macro auto processing
Related Commands Command
macro auto execute (built-in
function)
shell trigger
show shell functions
OL-25342 -01
macro auto processing [fallback cdp] [fallback lldp]
no macro auto processing [fallback cdp] [fallback lldp]
Specifies as CDP as the fallback mechanism.
Specifies as LLDP as the fallback mechanism.
Modification
This command was introduced on the Catalyst 4500 series switch.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
Description
Configures mapping from an event trigger to a built-in macro.
Creates a user defined trigger.
Displays configurations included for all the builtin functions
including user created and built-in functions.
macro auto processing
2-423