Cisco Catalyst 4500 Series Command Reference Manual page 901

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Switch#
The following example shows a configuration on a Supervisor Engine 6-E:
interface gigabitethernet3/1
vlan-range 100
service-policy in p1
This example shows how to display policy-map statistics on VLAN 100 on the FastEthernet interface:
Switch# show policy-map interface gigabitethernet 3/1 vlan 100
GigabitEthernet3/1 vlan 100
Service-policy input: p1
Switch#
Related Commands Command
service-policy (interface configuration)
show policy-map interface
OL-25342 -01
Class-map: c1 (match-all)
0 packets
Match: ip dscp af11 (10)
police: Per-interface
Conform: 0 bytes Exceed: 0 bytes
Class-map: class-default (match-any)
0 packets
Match: any
0 packets
Class-map: c1 (match-all)
0 packets
Match: ip dscp af11 (10)
police:
rate 128000 bps, burst 4000 bytes
conformed 0 packets, 0 bytes; action:
transmit
exceeded 0 packets, 0 bytes; action:
drop
conformed 0 bps, exceeded 0 bps
Class-map: class-default (match-any)
0 packets
Match: any
0 packets
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
Description
Attaches a policy map to an interface.
Displays the statistics and configurations of the input and
output policies that are attached to an interface.
show policy-map interface vlan
2-843