Cisco Catalyst 4500 Series Command Reference Manual page 707

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Table 2-17
Field
PortStatus
Port Control
MultiHosts
This is an example of output from the show dot1x statistics interface gigabitethernet1/1 command.
Table 2-18
Switch# show dot1x statistics interface gigabitethernet1/1
PortStatistics Parameters for Dot1x
--------------------------------------------
TxReqId = 0
RxStart = 0
RxInvalid = 0
RxVersion = 0
Switch#
Table 2-18
Field
TxReq/TxReqId
TxTotal
RxStart
RxLogoff
RxRespId
RxResp
RxInvalid
RxLenError
RxTotal
RxVersion
LastRxSrcMac
OL-25342 -01
show dot1x interface Field Description
Description
Status of the port (authorized or unauthorized). The status of a port is
displayed as authorized if the dot1x port-control interface configuration
command is set to auto and has successfully completed authentication.
Setting of the dot1x port-control interface configuration command.
Setting of the dot1x multiple-hosts interface configuration command
(allowed or disallowed).
describes the fields in the display.
TxReq = 0 TxTotal = 0
RxLogoff = 0 RxRespId = 0
RxLenErr = 0 RxTotal= 0
LastRxSrcMac 0000.0000.0000
show dot1x statistics Field Descriptions
Description
Number of EAP-request/identity frames that have been sent.
Number of EAPOL frames of any type that have been sent.
Number of valid EAPOL-start frames that have been received.
Number of EAPOL-logoff frames that have been received.
Number of EAP-response/identity frames that have been received.
Number of valid EAP-response frames (other than response/identity
frames) that have been received.
Number of EAPOL frames that have been received and have an
unrecognized frame type.
Number of EAPOL frames that have been received in which the packet
body length field is invalid.
Number of valid EAPOL frames of any type that have been received.
Protocol version number carried in the most recently received EAPOL
frame.
Source MAC address carried in the most recently received EAPOL
frame.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
RxResp = 0
show dot1x
2-649