Debug Ip Verify Source Packet - Cisco Catalyst 4500 Series Command Reference Manual

debug ip verify source packet

debug ip verify source packet
To debug the IP source guard messages, use the debug ip verify source packet command. To disable
the debugging output, use the no form of this command.
Syntax Description
This command has no arguments or keywords.
Defaults Debugging of snooping security packets is disabled.
Command Modes Privileged EXEC mode
Command History Release
12.1(12c)EW
Examples This example shows how to enable debugging for the IP source guard:
Switch# debug ip verify source packet
Switch#
This example shows how to disable debugging for the IP source guard:
Switch# no debug ip verify source packet
Switch#
Related Commands Command
ip dhcp snooping
ip dhcp snooping limit rate
ip dhcp snooping trust
show ip dhcp snooping
show ip dhcp snooping binding
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
2-154
debug ip verify source packet
no debug ip verify source packet
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Description
Globally enables DHCP snooping.
Enables DHCP option 82 data insertion.
Enables DHCP snooping on a trusted VLAN.
Displays the DHCP snooping configuration.
Displays the DHCP snooping binding entries.
OL-25342 -01