Cisco Catalyst 4500 Series Command Reference Manual page 320

hw-module uplink mode
Examples This example shows how to enable shared-backplane uplink mode:
Switch(config)# hw-module uplink mode shared-backplane
A reload of the active supervisor is required to apply the new configuration.
Switch(config)# exit
Switch#
This example shows how to disable shared-backplane uplink mode:
Switch(config)# no hw-module uplink mode shared-backplane
A reload of the active supervisor is required to apply the new configuration.
Switch(config)# exit
Switch#
This example shows how to display the current state of uplink-mode:
Switch# show hw-module uplink
Active uplink mode configuration is Default
(will be Shared-backplane after next reload)
A reload of active supervisor is required to apply the new configuration.
Related Commands Command
show hw-module uplink
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
2-262
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Description
Displays hardware-module uplink information.
OL-25342 -01