Hw-Module Module Start - Cisco Catalyst 4500 Series Command Reference Manual

hw-module module start

hw-module module start
The hw-module module start command is enabled only on the uplink modules of the WS-C4500X-32.
Note
To boot a module after if it has been stopped, use the hw-module module start command:
Syntax Description
number
Defaults none
Command Modes global configuration
Command History Release
IOS-XE 3.3.0SG
(15.1(1)SG)
Usage Guidelines To bring up a module that has been stopped using the hw-module module number stop command or by
pressing the OIR button, you either enter the hw-module module number start command or physically
remove and reinsert.
Examples
The following example shows what happens if a module has been stopped and you enter this command:
Switch# hw-module module 2 start
Switch#
*Feb
*Feb
JAE15340C0J Hw: 0.1) is online
Switch#show module
Chassis Type : WS-C4500X-32
Power consumed by backplane : 0 Watts
Mod Ports Card Type
---+-----+--------------------------------------+------------------+-----------
1
2
M MAC addresses
--+--------------------------------+---+------------+----------------+---------
1 0022.bde2.1061 to 0022.bde2.1080 0.2 15.0(1r)SG(0 0.DEV-0
2 0022.bde2.1579 to 0022.bde2.1580 0.1
Switch#
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
2-254
hw-module module number start
Uplink module ID. The only applicable value for WS-C4500 is 2.
Modification
Support for this command was introduced on WS-C4500X-32.
5 16:36:27.352: %C4K_IOSMODPORTMAN-6-MODULEINSERTED: Module 2 is inserted
5 16:37:15.902: %C4K_IOSMODPORTMAN-6-MODULEONLINE: Module 2 (WS-X4908X-10G-TIM S/N:
32 4500X-32 10GE (SFP+)
8 10GE SFP+
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Model
WS-C4900X-32P-10G
WS-X4908X-10G-TIM
Hw Fw Sw
Serial No.
JAE153505E9
JAE15340C0J
Status
Ok
Ok
OL-25342 -01