Debug Condition Standby - Cisco Catalyst 4500 Series Command Reference Manual

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches

debug condition standby

To limit the debugging output for the standby state changes, use the debug condition standby command.
To disable the debugging output, use the no form of this command.
Syntax Description
fastethernet
mod/port
GigabitEthernet
port-channel interface_num
vlan vlan_id
group-number
Defaults This command has no default settings.
Command Modes
Privileged EXEC mode
Command History Release
12.1(8a)EW
12.1(12c)EW
Usage Guidelines
If you attempt to remove the only condition set, you will be prompted with a message asking if you want
to abort the removal operation. You can enter n to abort the removal or y to proceed with the removal. If
you remove the only condition set, an excessive number of debugging messages might occur.
Examples
This example shows how to limit the debugging output to group 0 in VLAN 1:
Switch# debug condition standby vlan 1 0
Condition 3 set
Switch#
OL-25342 -01
debug condition standby {fastethernet mod/port | GigabitEthernet mod/port |
port-channel interface-num | vlan vlan_id group-number}
no debug condition standby {fastethernet mod/port | GigabitEthernet mod/port |
port-channel interface-num | vlan vlan_id group-number}
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Support for extended VLAN addresses added.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
Limits the debugging to Fast Ethernet interfaces.
Number of the module and port.
Limits the debugging to Gigabit Ethernet interfaces.
Limits the debugging output to port-channel interfaces; valid values
are from 1 to 64.
Limits the debugging of a condition on a VLAN interface; valid values
are from 1 to 4094.
VLAN group number; valid values are from 0 to 255.
debug condition standby
2-143