Cisp Enable - Dell Catalyst 3130 Command Reference Manual

cisp enable

cisp enable
Use the cisp enable global configuration command to enable Client Information Signalling Protocol
(CISP) on a switch so that it acts as an authenticator to a supplicant switch.
Syntax Description
cisp enable
Defaults There is no default setting.
Command Modes Global configuration
Command History Release
12.2(50)SE
Usage Guidelines The link between the authenticator and supplicant switch is a trunk. When you enable VTP on both
switches, the VTP domain name must be the same, and the VTP mode must be server.
When you configure VTP mode, to avoid the MD5 checksum mismatch error, verify that:
•
•
Examples This example shows how to enable CISP:
switch(config)# cisp enable
Related Commands Command
dot1x credentials (global
configuration)
show cisp
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
2-66
cisp enable
no cisp enable
Enable CISP.
Modification
This command was introduced.
VLANs are not configured on two different.switches, which can be caused by two VTP servers in
the same domain.
Both switches have the different configuration revision numbers.
profile
Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands
Description
Configures a profile on a supplicant switch.
Displays CISP information for a specified interface.
OL-13271-03