Nmsp - Dell Catalyst 3130 Command Reference Manual

nmsp

nmsp
Use the nmsp global configuration command to enable Network Mobility Services Protocol (NMSP) on
the switch. This command is available only when your switch is running the cryptographic (encrypted)
software image. Use the no form of this command to return to the default setting.
Syntax Description
enable
notification interval
attachment
location
interval-seconds
Defaults NMSP is disabled.
Command Modes
Global configuration
Command History Release
12.2(50)SE
Usage Guidelines
Use the nmsp global configuration command to enable the switch to send NMSP location and
attachment notifications to a Cisco Mobility Services Engine (MSE).
Examples
This example shows how to enable NMSP on a switch and set the location notification time to 10
seconds:
Switch(config)#nmsp enable
Switch(config)#nmsp notification interval location 10
Related Commands Command
clear nmsp statistics
nmsp attachment suppress
show nmsp
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
2-376
nmsp {enable | {notification interval {attachment | location} interval-seconds}}
no nmsp {enable | {notification interval {attachment | location} interval-seconds}}
Modification
This command was introduced.
Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands
Enable the NMSP features on the switch.
Specify the NMSP notification interval.
Specify the attachment notification interval.
Specify the location notification interval.
Duration in seconds before a switch sends the MSE the location or
attachment updates. The range is 1 to 30; the default is 30.
Description
Clears the NMSP statistic counters.
Suppresses reporting attachment information from a specified
interface.
Displays the NMSP information.
OL-13271-03