Dell Catalyst 3130 Command Reference Manual page 607

Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
Table 2-30
Table 2-30
Field
LACPDUs Sent and Recv
Marker Sent and Recv
Marker Response Sent and Recv
LACPDUs Pkts and Err
This is an example of output from the show lacp internal command:
Switch> show lacp 1 internal
Flags:
Channel group 1
Port
Gi2/0/1
Gi2/0/2
Table 2-31
Table 2-31
Field
State
LACP Port Priority
OL-12248-03
describes the fields in the display.
show lacp counters Field Descriptions
S - Device is requesting Slow LACPDUs
F - Device is requesting Fast LACPDUs
A - Device is in Active mode
LACP port
Flags State Priority
SA bndl 32768
SA bndl 32768
describes the fields in the display:
show lacp internal Field Descriptions
Description
The number of LACP packets sent and received by a port.
The number of LACP marker packets sent and received by a port.
The number of LACP marker response packets sent and received
by a port.
The number of unknown and illegal packets received by LACP
for a port.
P - Device is in Passive mode
Admin Oper
Key Key
0x3 0x3
0x3 0x3
Description
State of the specific port. These are the allowed values:
– —Port is in an unknown state.
•
bndl—Port is attached to an aggregator and bundled with
•
other ports.
susp—Port is in a suspended state; it is not attached to any
•
aggregator.
• hot-sby—Port is in a hot-standby state.
• indiv—Port is incapable of bundling with any other port.
indep—Port is in an independent state (not bundled but able
•
to switch data traffic. In this case, LACP is not running on
the partner port).
• down—Port is down.
Port priority setting. LACP uses the port priority to put ports s
in standby mode when there is a hardware limitation that
prevents all compatible ports from aggregating.
Cisco Catalyst Blade Switch 3120 for HP Command Reference
show lacp
Port Port
Number State
0x4 0x3D
0x5 0x3D
2-577