debug platform ip multicast
Usage Guidelines
The undebug platform ip multicast command is the same as the no debug platform ip multicast
command.
On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. To
enable debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
Command
show debugging
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
B-44
Appendix B
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands
Description
Displays information about the types of debugging that are enabled.
OL-13271-03