Debug Platform Matm - Dell Catalyst 3130 Command Reference Manual

debug platform matm

debug platform matm
Use the debug platform matm privileged EXEC command to enable debugging of platform-dependent
MAC address management. Use the no form of this command to disable debugging.
Syntax Description
aging
all
ec-aging
errors
learning
rpc
secure-address
warning
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(40)EX1
Usage Guidelines The undebug platform matm command is the same as the no debug platform matm command.
On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. To
enable debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands Command
debug matm
show debugging
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
B-50
debug platform matm {aging | all | ec-aging | errors | learning | rpc | secure-address | warnings}
no debug platform matm {aging | all | ec-aging | errors | learning | rpc | secure-address |
warnings}
Display MAC address aging debug messages.
Display all platform MAC address management event debug messages.
Display EtherChannel address aging-related debug messages.
Display MAC address management error messages.
Display MAC address management address-learning debug messages.
Display MAC address management remote procedure call (RPC) related debug
messages.
Display MAC address management secure address learning debug messages.
Display MAC address management warning messages.
Modification
This command was introduced.
Description
Displays information about platform-independent MAC address management.
Displays information about the types of debugging that are enabled.
Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands
OL-13271-03