Table of Contents
Advertisement
Appendix B
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands
debug platform cli-redirection main
Use the debug platform cli-redirection main privileged EXEC command to enable debugging of the
main (important) command-line interface (CLI) redirection events. Use the no form of this command to
disable debugging.
This command is supported only on stacking-capable switches.
Note
Syntax Description
This command has no arguments or keywords.
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Release
12.2(40)EX1
Usage Guidelines
The undebug platform cli-redirection main command is the same as the no debug platform
cli-redirection main command.
On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. To
enable debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
Command
show debugging
OL-13271-03
debug platform cli-redirection main
no debug platform cli-redirection main
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
debug platform cli-redirection main
B-31
Advertisement
Table of Contents
