Dell Catalyst 3130 Command Reference Manual page 708

show vlan
20
20
2000
This is an example of output from the show vlan private-vlan type command:
Switch> show vlan private-vlan type
Vlan Type
---- -----------------
10
501
502
503
This is an example of output from the show vlan summary command:
Switch> show vlan summary
Number of existing VLANs
Number of existing VTP VLANs
Number of existing extended VLANs : 0
This is an example of output from the show vlan id command.
Switch# show vlan id 2
VLAN Name
---- -------------------------------- --------- -------------------------------
2
2
VLAN Type
---- ----- ---------- ----- ------ ------ -------- ---- -------- ------ ------
2
Remote SPAN VLAN
----------------
Disabled
This is an example of output from the show vlan internal usage command. It shows that VLANs 1025
and 1026 are being used as internal VLANs for Gigabit Ethernet routed ports 7 and 8 on stack member 1.
If you want to use one of these VLAN IDs, you must first shut down the routed port, which releases the
internal VLAN, and then create the extended-range VLAN. When you start up the routed port, another
internal VLAN number is assigned to it.
Switch> show vlan internal usage
VLAN Usage
---- -------------
1025 GigabitEthernet1/0/7
1026 GigabitEthernet1/0/8
Cisco Catalyst Blade Switch 3120 for HP Command Reference
2-678
35 community
55 non-operational
2500 isolated
primary
isolated
community
normal
VLAN0200
VLAN0200
SAID MTU
enet 100002 1500
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
Gi1/0/13, Gi1/0/1,
Gi2/0/13, Gi3/0/14, Gi3/0/1
Gi1/0/5, Gi1/0/10, Gi2/0/5, Gi2/0/10
: 45
: 45
Status Ports
active Gi1/0/7, Gi1/0/8
active Gi2/0/1, Gi2/0/2
Parent RingNo BridgeNo Stp
- - -
BrdgMode Trans1 Trans2
- - 0 0
OL-12248-03