Dell Catalyst 3130 Command Reference Manual page 726

snmp-server enable traps
Defaults The sending of SNMP traps is disabled.
Command Modes Global configuration
Command History Release
12.2(40)EX1
12.2(46)SE
12.2(50)SE
Usage Guidelines Specify the host (NMS) that receives the traps by using the snmp-server host global configuration
command. If no trap types are specified, all trap types are sent.
When supported, use the snmp-server enable traps command to enable sending of traps or informs.
Note Informs are not supported in SNMPv1.
To enable more than one type of trap, you must enter a separate snmp-server enable traps command
for each trap type.
Examples
This example shows how to send VTP traps to the NMS:
Switch(config)# snmp-server enable traps vtp
You can verify your setting by entering the show vtp status or the show running-config privileged
EXEC command.
Related Commands Command
show running-config
snmp-server host
Cisco Catalyst Blade Switch 3120 for HP Command Reference
2-696
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
Modification
This command was introduced.
The dot1x [ auth-fail-vlan | guest-vlan | no-auth-fail-vlan | no-guest-vlan ]
keywords were added.
The cpu threshold keywords were added.
Description
Displays the operating configuration. For syntax information, use this link
to the Cisco IOS Release 12.2 Command Reference listing page:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/prod_command
_reference_list.html
Select the Cisco IOS Commands Master List, Release 12.2 to navigate to
the command.
Specifies the host that receives SNMP traps.
OL-12248-03