Table of Contents
Advertisement
switchport mode
Examples
This example shows how to configure a port for access mode:
Switch(config)# interface gigabitethernet2/0/1
Switch(config-if)# switchport mode access
This example shows how set the port to dynamic desirable mode:
Switch(config)# interface gigabitethernet2/0/1
Switch(config-if)# switchport mode dynamic desirable
This example shows how to configure a port for trunk mode:
Switch(config)# interface gigabitethernet2/0/1
Switch(config-if)# switchport mode trunk
This example shows how to configure a port as an IEEE 802.1Q tunnel port:
Switch(config)# interface gigabitethernet2/0/1
Switch(config-if)# switchport mode dot1q-tunnel
You can verify your settings by entering the show interfaces interface-id switchport privileged EXEC
command and examining information in the Administrative Mode and Operational Mode rows.
Related Commands
Command
show interfaces
switchport access
switchport trunk
Cisco Catalyst Blade Switch 3120 for HP Command Reference
2-782
Description
switchport
Displays the administrative and operational status of a switching
(nonrouting) port, including port blocking and port protection
settings.
Configures a port as a static-access or dynamic-access port.
Configures the trunk characteristics when an interface is in trunking
mode.
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
OL-12248-03
Advertisement
Table of Contents
