Dot1X Default - Dell Catalyst 3130 Command Reference Manual

Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands

dot1x default

Use the dot1x default interface configuration command on the switch stack or on a standalone switch
to reset the IEEE 802.1x parameters to their default values.
Syntax Description This command has no arguments or keywords.
Defaults
These are the default values:
•
•
•
•
•
•
•
•
•
Command Modes
Interface configuration
Command History Release
12.2(40)EX1
Examples This example shows how to reset the IEEE 802.1x parameters on a port:
Switch(config-if)# dot1x default
You can verify your settings by entering the show dot1x [interface interface-id] privileged EXEC
command.
Related Commands Command
show dot1x
OL-13271-03
dot1x default
The per-port IEEE 802.1x protocol enable state is disabled (force-authorized).
The number of seconds between re-authentication attempts is 3600 seconds.
The periodic re-authentication is disabled.
The quiet period is 60 seconds.
The retransmission time is 30 seconds.
The maximum retransmission number is 2 times.
The host mode is single host.
The client timeout period is 30 seconds.
The authentication server timeout period is 30 seconds.
Modification
This command was introduced.
[interface interface-id]
Description
Displays IEEE 802.1x status for the specified port.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
dot1x default
2-131