Table of Contents
Advertisement
Chapter 2
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands
monitor session
Use the monitor session global configuration command on the switch stack or on a standalone switch
to start a new Switched Port Analyzer (SPAN) session or Remote SPAN (RSPAN) source or destination
session, to enable ingress traffic on the destination port for a network security device (such as a Cisco
IDS Sensor Appliance), to add or delete interfaces or VLANs to or from an existing SPAN or RSPAN
session, and to limit (filter) SPAN source traffic to specific VLANs. Use the no form of this command
to remove the SPAN or RSPAN session or to remove source or destination interfaces or filters from the
SPAN or RSPAN session. For destination interfaces, the encapsulation options are ignored with the no
form of the command.
Syntax Description
session_number
destination
interface interface-id
encapsulation replicate
ingress
dot1q vlan vlan-id
isl
OL-13271-03
monitor session session_number destination {interface interface-id [, | -] [encapsulation
replicate] [ingress {dot1q vlan vlan-id | isl | untagged vlan vlan-id | vlan vlan-id}]} | {remote
vlan vlan-id}
monitor session session_number filter vlan vlan-id [, | -]
monitor session session_number source {interface interface-id [, | -] [both | rx | tx]} | {vlan
vlan-id [, | -] [both | rx | tx]} | {remote vlan vlan-id}
no monitor session {session_number | all | local | remote}
no monitor session session_number destination {interface interface-id [, | -] [encapsulation
replicate] [ingress {dot1q vlan vlan-id | isl | untagged vlan vlan-id | vlan vlan-id}]} | {remote
vlan vlan-id}
no monitor session session_number filter vlan vlan-id [, | -]
no monitor session session_number source {interface interface-id [, | -] [both | rx | tx]} | {vlan
vlan-id [, | -] [both | rx | tx]} | {remote vlan vlan-id}
Specify the session number identified with the SPAN or RSPAN session.
The range is 1 to 66.
Specify the SPAN or RSPAN destination. A destination must be a physical
port.
Specify the destination or source interface for a SPAN or RSPAN session.
Valid interfaces are physical ports (including type, stack member, module,
and port number). For source interface, port channel is also a valid
interface type, and the valid range is 1 to 64.
(Optional) Specify that the destination interface replicates the source
interface encapsulation method. If not selected, the default is to send
packets in native form (untagged).
These keywords are valid only for local SPAN. For RSPAN, the RSPAN
VLAN ID overwrites the original VLAN ID; therefore, packets are always
sent untagged.
(Optional) Enable ingress traffic forwarding.
Accept incoming packets with IEEE 802.1Q encapsulation with the
specified VLAN as the default VLAN.
Specify ingress forwarding using ISL encapsulation.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
monitor session
2-363
Advertisement
Table of Contents
