Errdisable Detect Cause - Dell Catalyst 3130 Command Reference Manual

errdisable detect cause

errdisable detect cause
Use the errdisable detect cause global configuration command on the switch stack or on a standalone
switch to enable error-disabled detection for a specific cause or all causes. Use the no form of this
command to disable the error-disabled detection feature.
For the BPDU guard and port-security features, you can use this command to globally configure the
switch to shut down just the offending VLAN on the port when a violation occurs, instead of shutting
down the entire port.
When the per-VLAN error-disable feature is turned off and a BPDU guard violation occurs, the entire
port is disabled. Use the no form of this command to disable the per-VLAN error-disable feature.
Syntax Description
all
arp-inspection
bpduguard shutdown vlan
dhcp-rate-limit
dtp-flap
gbic-invalid
l2ptguard
link-flap
loopback
pagp-flap
sfp-config-mismatch
Though visible in the command-line help strings, the inline-power keyword is not supported.
Note
Defaults
Detection is enabled for all causes.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
2-162
errdisable detect cause {all | arp-inspection | bpduguard | dhcp-rate-limit | dtp-flap |
gbic-invalid | l2ptguard | link-flap | loopback | pagp-flap | sfp-config-mismatch}
no errdisable detect cause {all | arp-inspection | bpduguard | dhcp-rate-limit | dtp-flap |
gbic-invalid | l2ptguard | link-flap | loopback | pagp-flap | sfp-config-mismatch}
errdisable detect cause bpduguard shutdown vlan
no errdisable detect cause bpduguard shutdown vlan
Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands
Enable error detection for all error-disabled causes.
Enable error detection for dynamic Address Resolution Protocol
(ARP) inspection.
Enable per-VLAN error-disable for BPDU guard.
Enable error detection for DHCP snooping.
Enable error detection for the Dynamic Trunking Protocol (DTP)
flapping.
Enable error detection for an invalid Gigabit Interface Converter
(GBIC) module.
This error refers to an invalid small form-factor pluggable
Note
(SFP) module.
Enable error detection for a Layer 2 protocol-tunnel error-disabled
cause.
Enable error detection for link-state flapping.
Enable error detection for detected loopbacks.
Enable error detection for the Port Aggregation Protocol (PAgP) flap
error-disabled cause.
Enable error detection on an SFP configuration mismatch.
OL-13271-03