Dell Catalyst 3130 Command Reference Manual page 78

auto qos voip
disabled, there is no concept of trusted or untrusted ports because the packets are not modified (the CoS,
DSCP, and IP precedence values in the packet are not changed). Traffic is switched in pass-through mode
(packets are switched without any rewrites and classified as best effort without any policing).
Examples
This example shows how to enable auto-QoS and to trust the QoS labels received in incoming packets
when the switch or router connected to the port is a trusted device:
Switch(config)# interface gigabitethernet2/0/1
Switch(config-if)# auto qos voip trust
You can verify your settings by entering the show auto qos interface interface-id privileged EXEC
command.
Related Commands Command
debug auto qos
mls qos cos
mls qos map
| dscp-cos dscp-list to cos}
mls qos queue-set output buffers
mls qos srr-queue input bandwidth
mls qos srr-queue input buffers
mls qos srr-queue input cos-map
mls qos srr-queue input dscp-map
mls qos srr-queue input
priority-queue
mls qos srr-queue output cos-map
mls qos srr-queue output dscp-map
mls qos trust
queue-set
show auto qos
show mls qos interface
srr-queue bandwidth shape
srr-queue bandwidth share
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
2-48
Chapter 2
{cos-dscp dscp1 ... dscp8
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands
Description
Enables debugging of the auto-QoS feature.
Defines the default CoS value of a port or assigns the default
CoS to all incoming packets on the port.
Defines the CoS-to-DSCP map or the DSCP-to-CoS map.
Allocates buffers to a queue-set.
Assigns shaped round robin (SRR) weights to an ingress
queue.
Allocates the buffers between the ingress queues.
Maps CoS values to an ingress queue or maps CoS values to
a queue and to a threshold ID.
Maps DSCP values to an ingress queue or maps DSCP values
to a queue and to a threshold ID.
Configures the ingress priority queue and guarantees
bandwidth.
Maps CoS values to an egress queue or maps CoS values to
a queue and to a threshold ID.
Maps DSCP values to an egress queue or maps DSCP values
to a queue and to a threshold ID.
Configures the port trust state.
Maps a port to a queue-set.
Displays auto-QoS information.
Displays QoS information at the port level.
Assigns the shaped weights and enables bandwidth shaping
on the four egress queues mapped to a port.
Assigns the shared weights and enables bandwidth sharing
on the four egress queues mapped to a port.
OL-13271-03