Switch Renumber - Dell Catalyst 3130 Command Reference Manual

Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands

switch renumber

Use the switch renumber global configuration command on the stack master to change the stack
member number.
Note This command is supported only on stacking-capable switches.
Syntax Description current-stack-member-number
renumber
new-stack-member-number
Defaults
The default stack member number is 1.
Command Modes Global configuration
Command History Release
12.2(40)EX1
Usage Guidelines
If another stack member is already using the member number that you just specified, the stack master
assigns the lowest available number when you reload the stack member.
If you change the number of a stack member, and no configuration is associated with the new stack
Note
member number, that stack member loses its current configuration and resets to its default configuration.
For more information about stack member numbers and configurations, see the software configuration
guide.
Do not use the switch current-stack-member-number renumber new-stack-member-number command
on a provisioned switch. If you do, the command is rejected.
Use the reload slot current stack member number privileged EXEC to reload the stack member and to
apply this configuration change.
Examples This example shows how to change the member number of stack member 6 to 7:
Switch(config)# switch 6 renumber 7
WARNING:Changing the switch number may result in a configuration change for that switch.
The interface configuration associated with the old switch number will remain as a
provisioned configuration.
Do you want to continue?[confirm]
OL-12248-03
switch current-stack-member-number renumber new-stack-member-number
Modification
This command was introduced.
Specify the current stack member number. The range is 1 to 9.
Specify the new stack member number for the stack member. The
range is 1 to 9.
Cisco Catalyst Blade Switch 3120 for HP Command Reference
switch renumber
2-767