Show Controllers Ethernet-Controller Fastethernet - Dell Catalyst 3130 Command Reference Manual

Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands

show controllers ethernet-controller fastethernet

Use the show controllers ethernet-controller fastethernet privileged EXEC command to display
information about the Ethernet management port, including the port status and the per-interface send and
receive statistics read from the hardware.
Syntax Description phy [detail]
stack
| begin
| exclude
| include
expression
Command Modes Privileged EXEC (only supported with the fastethernet 0 keywords in user EXEC mode)
Command History Release
12.2(40)EX1
Usage Guidelines The output display provides information that might be useful for Cisco technical support representatives
troubleshooting the switch.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
OL-12248-03
show controllers ethernet-controller fastethernet 0 [phy [detail] | stack] [ | {begin | exclude |
include} expression]
(Optional) Display the status of the internal registers on the switch physical layer
device (PHY) for the Ethernet management port on the switch when the command
is entered on a switch. Display the status of the internal registers on the switch
PHYs for all the Ethernet management ports in the switch stack when the
command is entered on a stack master or member.
Use the detail keyword to display details about the PHY internal registers.
This display includes the operational state of the automatic medium-dependent
interface crossover (auto-MDIX) feature on an interface.
(Optional) Display the speed, duplex mode, and link states of the Ethernet
management ports in the switch stack when the command is entered on a stack
master or member.
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
show controllers ethernet-controller fastethernet
Cisco Catalyst Blade Switch 3120 for HP Command Reference
2-471