Table of Contents
Advertisement
Chapter 2
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands
l2protocol-tunnel cos
Use the l2protocol-tunnel cos global configuration command on the switch stack or on a standalone
switch to configure class of service (CoS) value for all tunneled Layer 2 protocol packets. Use the no
form of this command to return to the default setting.
Syntax Description
value
Defaults
The default is to use the CoS value configured for data on the interface. If no CoS value is configured,
the default is 5 for all tunneled Layer 2 protocol packets.
Command Modes
Global configuration
Command History
Release
12.2(40)EX1
Usage Guidelines
When enabled, the tunneled Layer 2 protocol packets use this CoS value.
The value is saved in NVRAM.
Examples
This example shows how to configure a Layer-2 protocol-tunnel CoS value of 7:
Switch(config)# l2protocol-tunnel cos 7
Related Commands
Command
show l2protocol-tunnel
OL-13271-03
l2protocol-tunnel cos value
no l2protocol-tunnel cos
Specify CoS priority value for tunneled Layer 2 protocol packets. If a CoS
value is configured for data packets for the interface, the default is to use
this CoS value. If no CoS value is configured for the interface, the default
is 5. The range is 0 to 7, with 7 being the highest priority.
Modification
This command was introduced.
Description
Displays information about ports configured for Layer 2 protocol
tunneling, including CoS.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
l2protocol-tunnel cos
2-281
Advertisement
Table of Contents
