Dell Catalyst 3130 Command Reference Manual page 802

switchport access
These restrictions apply to dynamic-access ports:
•
•
•
•
•
Examples
This example shows how to change a switched port interface that is operating in access mode to operate
in VLAN 2 instead of the default VLAN:
Switch(config-if)# switchport access vlan 2
You can verify your setting by entering the show interfaces interface-id switchport privileged EXEC
command and examining information in the Administrative Mode and Operational Mode rows.
Related Commands Command
show interfaces
switchport mode
Cisco Catalyst Blade Switch 3120 for HP Command Reference
2-772
The software implements the VLAN Query Protocol (VQP) client, which can query a VMPS such
as a Catalyst 6000 series switch. The switches are not VMPS servers. The VMPS server must be
configured before a port is configured as dynamic.
Use dynamic-access ports only to connect end stations. Connecting them to switches or routers (that
use bridging protocols) can cause a loss of connectivity.
Configure the network so that STP does not put the dynamic-access port into an STP blocking state.
The Port Fast feature is automatically enabled on dynamic-access ports.
Dynamic-access ports can only be in one VLAN and do not use VLAN tagging.
Dynamic-access ports cannot be configured as
Members of an EtherChannel port group (dynamic-access ports cannot be grouped with any
–
other port, including other dynamic ports).
Source or destination ports in a static address entry.
–
Monitor ports.
–
switchport
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
Description
Displays the administrative and operational status of a switching
(nonrouting) port, including port blocking and port protection settings.
Configures the VLAN membership mode of a port.
OL-12248-03