Spanning-Tree Etherchannel Guard Misconfig - Dell Catalyst 3130 Command Reference Manual

spanning-tree etherchannel guard misconfig

spanning-tree etherchannel guard misconfig
Use the spanning-tree etherchannel guard misconfig global configuration command to display an
error message when the switch detects an EtherChannel misconfiguration. Use the no form of this
command to disable the feature.
Syntax Description
This command has no arguments or keywords.
Defaults
EtherChannel guard is enabled on the switch.
Command Modes Global configuration
Command History Release
12.2(40)EX1
Usage Guidelines
When the switch detects an EtherChannel misconfiguration, this error message appears:
PM-4-ERR_DISABLE: Channel-misconfig error detected on [chars], putting [chars] in
err-disable state.
To show switch ports that are in the misconfigured EtherChannel, use the show interfaces status
err-disabled privileged EXEC command. To verify the EtherChannel configuration on a remote device,
use the show etherchannel summary privileged EXEC command on the remote device.
When a port is in the error-disabled state because of an EtherChannel misconfiguration, you can bring
it out of this state by entering the errdisable recovery cause channel-misconfig global configuration
command, or you can manually re-enable it by entering the shutdown and no shut down interface
configuration commands.
Examples
This example shows how to enable the EtherChannel guard misconfiguration feature:
Switch(config)# spanning-tree etherchannel guard misconfig
You can verify your settings by entering the show spanning-tree summary privileged EXEC command.
Cisco Catalyst Blade Switch 3120 for HP Command Reference
2-710
spanning-tree etherchannel guard misconfig
no spanning-tree etherchannel guard misconfig
Modification
This command was introduced.
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
OL-12248-03