Debug Dtp - Dell Catalyst 3130 Command Reference Manual

Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands

debug dtp

Use the debug dtp privileged EXEC command to enable debugging of the Dynamic Trunking Protocol
(DTP) activity. Use the no form of this command to disable debugging.
Syntax Description
aggregation
all
decision
events
oserrs
packets
queue
states
timers
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.2(40)EX1
Usage Guidelines
The undebug dtp command is the same as the no debug dtp command.
On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. To
enable debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands Command
show debugging
show dtp
OL-13271-03
debug dtp {aggregation | all | decision | events | oserrs | packets | queue | states | timers}
no debug dtp {aggregation | all | decision | events | oserrs | packets | queue | states | timers}
Display DTP user-message aggregation debug messages.
Display all DTP debug messages.
Display the DTP decision-table debug messages.
Display the DTP event debug messages.
Display DTP operating system-related error debug messages.
Display DTP packet-processing debug messages.
Display DTP packet-queueing debug messages.
Display DTP state-transition debug messages.
Display DTP timer-event debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Displays DTP information for the switch or for a specified interface.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
debug dtp
B-7