Switchport Mode Private-Vlan - Dell Catalyst 3130 Command Reference Manual

Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands

switchport mode private-vlan

Use the switchport mode private-vlan interface configuration command on the switch stack or on a
standalone switch to configure a port as a promiscuous or host private VLAN port. Use the no form of
this command to reset the mode to the appropriate default for the device.
Syntax Description
host
promiscuous
Defaults
The default private-VLAN mode is neither host nor promiscuous.
The default switchport mode is dynamic auto.
Command Modes
Interface configuration
Command History Release
12.2(40)EX1
Usage Guidelines
A private-VLAN host or promiscuous port cannot be a Switched Port Analyzer (SPAN) destination port.
If you configure a SPAN destination port as a private-VLAN host or promiscuous port, the port becomes
inactive.
Do not configure private VLAN on ports with these other features:
•
•
•
•
•
•
A private-VLAN port cannot be a SPAN destination port.
While a port is part of the private-VLAN configuration, any EtherChannel configuration for it is
inactive.
A private-VLAN port cannot be a secure port and should not be configured as a protected port.
OL-12248-03
switchport mode private-vlan {host | promiscuous}
no switchport mode private-vlan
Configure the interface as a private-VLAN host port. Host ports belong to
private-VLAN secondary VLANs and are either community ports or isolated
ports, depending on the VLAN that they belong to.
Configure the interface as a private-VLAN promiscuous port. Promiscuous
ports are members of private-VLAN primary VLANs.
Modification
This command was introduced.
Dynamic-access port VLAN membership
Dynamic Trunking Protocol (DTP)
Port Aggregation Protocol (PAgP)
Link Aggregation Control Protocol (LACP)
Multicast VLAN Registration (MVR)
Voice VLAN
Cisco Catalyst Blade Switch 3120 for HP Command Reference
switchport mode private-vlan
2-783